How To Fix The Natro Macro Resetting My Character Issue
If your character keeps resetting at spawn or walking into walls, something in your setup is likely incorrect. This usually happens because of a wrong hive slot, incorrect movespeed, or camera settings that the macro does not work well with.
Before you start troubleshooting the “Natro Macro Resetting My Character” issue, make sure to go through the GUI offset fixes first, as many reset issues are caused by this area. If the problem still persists, this guide covers everything you need to check and fix.
Fix “Natro Macro Resetting My Character” Issue [Step-by-Step Guide]
If your character (or avatar) keeps resetting at spawn or walking into walls (especially near Honey Wreath), first complete the GUI offset fixes above. Many reset loops trace back to display or detection errors. If the issue continues, follow this section carefully.
Causes
Fixes
1. Adjust Roblox In-Game Settings
Complete all the Roblox settings discussed above, and then apply these additional settings:
- Shift-Lock: Off (if using the Microsoft Store version of Roblox)
- Full-Screen: Off (Microsoft Store version) or your preference (web version)
- Reduce Background Motion: Off
- UI Navigation Toggle: Off
2. Set Correct Hive Slot and Bee Number
Pre-claim your hive before starting the macro (make sure your character is standing on the claimed hive). Then,
- Enter the correct hive slot number in Natro Macro settings (6 means far left, 1 is for far right (right beside Red cannon).
- Set the exact number of bees in the hive. For example, if you have 67 bees, enter 67.
If Natro opens without the game, it will claim the closest available hive and update settings automatically. (double check for accuracy)
3. Configure Movespeed and Movement Method
Open the Bee Swarm Simulator in-game settings and do this:
- See the “movespeed” after removing haste, buffs, or bear morphs.
- Enter the exact movespeed number in the Natro Macro Settings tab using a decimal point.
- For the move method in Natro Macro, make sure to select based on your level:
- Use Cannon only if the red cannon and required gear are unlocked
- Otherwise use Walk
- If cannon overshoots, switch to Walk.
4. Allow Macro to Reset if Needed
The macro may reset 2 to 10 times before locking onto the hive. As you click “F1 to start the macro, wait for a while. After several resets (5-10), wait a few seconds for the character to spawn, return to the hive, and begin movement toward the target field. Once at the field, the macro will place sprinklers and start collecting automatically.
If the macro still fails to stop at hives or cannons, refer to the “Fixing Natro Macro Not Moving” guide given below.
Final Words
Once your hive slot, bee count, and movespeed are set correctly, the macro should run without issues. Keep in mind that resetting a few times after starting is completely normal, as the macro does this while locking onto your hive before settling into its routine.
Make sure your camera and movement settings are set to default, and that no buffs or morphs are active when checking your movespeed. Go through each step carefully and do not rush the process. Once everything is configured correctly, the macro will place sprinklers and start collecting on its own.
